Do Prime And Paint Cut Ends Of Truwood Siding

Cutting cut with conventional tools into the face to be exposed.

Do prime and paint cut ends of truwood siding.

Therefore do not prime the back side of the siding or trim. Additional primer is not needed field painting guidance for best results with our primed siding products. Make sure to prime and paint all exposed cut edges. Roof and gutters are adjacent to the siding.

Use high quality waterborne 100 acrylic exterior paints apply a finish coat within 180 days of installation do not paint wet siding ensure the surface is clean dry and free of any dust dirt or mildew do not use. Provide a 1 in. Make sure to prime and paint all cut edges. Back priming helps prevent paint from peeling by reducing the amount of water vapor that passes through the wood.

According to the terms of lp s application instructions all exposed edges of lp smartside siding and trim must be primed and painted with approved paint to protect the siding substrate. The back side is better left unpainted. If trim is cut to fit around door and window openings raw edges. When back priming be sure to prime the ends of each piece after it has been cut to fit since end grain will absorb the most moisture.

Do not paint in wet or cold conditions. Watch this video to find out more. Do not bevel cut the siding edges at butt joints. Priming and sealing end grain during the wood siding deck or trim installation can be easily accomplished and does little to slow down a job.

I would strongly suggest priming the front back edges and ends of your pine siding with an oil based exterior primer before installation. Clearance between the gutter end and trim see fig. Truwood siding meets the requirements of the following codes and standards. All it takes is a little can of paint or sealer.

Spray cans or primer or disposable cans and brushes with primer can be used to prime the end grain once installed.