Diy Remove Wall To Wall Carpet

Pull up a few feet of carpet and fold it over.

Diy remove wall to wall carpet.

Once all of the carpet has been removed it s time to remove the padding following the same steps outlined above image 1. Using an automatic or electric stretching machine stretch the carpet in place. Use a utility knife with a sharp new blade to cut through the carpet backing. Diy experts show how to install wall to wall carpet in any room.

Protective gloves should be worn to protect hands from staples and while cutting the carpet and handling tack strips. The most time consuming step in the process is removing staples. Pulling up carpet depends on the reason the carpet needs to be pulled up. If the goal is simply to get the old carpet out of the way protect your hands with heavy gloves and use a sharp utility knife to cut a border around the entire area about four or five inches away from the walls.

Use pliers to pull each staple from the subfloor image 2 then place staples into disposable plastic cup. Old carpet can be full of dust so be sure to wear a dust mask. Roll or fold the strip secure with duct tape and remove it. Make sure it is taught.

Take a look at the room and check to see that your wrinkles have been removed from the carpet. When the corner of the carpet is loose use your gloved hands to pull along the length of the wall. How to install a carpet runner on wooden stairs installing a carpet runner using tackless strips adds color and comfort to stairs and can be accomplished by a diyer of any skill level. Push the carpet inside the gully.